Event ID 1014: Microsoft Windows DNS Client

admin

Applies toWindows Server 2008, Windows Vista,  Windows 7, Windows Server 2008 R2

Details

Product	Windows Operating System
ID	1014
Source	Microsoft Windows DNS Client
Version	6.1
Symbolic Name
Message	Name resolution for the name %1 timed out after none of the configured DNS servers responded.

Causes

Customers have reported the following scenarios as possible causes for this event:

  -  TCP/IP Offload is enabled for a network adapter
   -  TCP/IP v6 is enabled and their ISP does not yet support TCP/IP v6.
  -  The spanning tree “portfast" setting is not enabled on your servers switch ports.
   -  Router and PC communicating on different channel or standard.
User ActionMethod one: Disable RSS, Autotuning, and Taskoffload1.   Run the following command in an elevated command prompt in Windows 7:

netsh interface tcp set global rss=disabled
netsh interface tcp set global autotuninglevel=disabled
netsh int ip set global taskoffload=disabled

2.  Disable the Scalable Networking Pack (SNP) in Windows 7 by changing the registry settings as follows:

Perform a full-system backup before you disable the SNP.

[HKEY_LOCAL_MACHINE\SYSTEM\CurrentControlSet\Services\Tcpip\Parameters]

EnableTCPChimney=dword:00000000
EnableTCPA=dword:00000000
EnableRSS=dword:00000000
  
If the registry keys do not exist, create them, and then assign the previous values.
Method two : Disable TCP/IP v6To disable TCP/IP v6

1.  Click Start, click Control Panel, click Network and Internet, and then click
View network status and tasks.

2.  In the left pane, click Manage Network Connections.

3.  Right-click Local Area Connection, and then click Properties.

4.  In the pop-up box, clear the Internet Protocol Version 6 (TCP/IPv6) check box.

5.  Click OK, and then restart your computer.

To enable TCP/IP v6

1.  Follow steps 1 through 3 in the previous procedure.

2.  In the pop-up box, select the Internet Protocol Version 6 (TCP/IPv6) check box.

3.  Click OK, and then restart your computer.
Method three: Enable the spanning tree portfast setting in your router

This action varies depending on your infrastructure router. Consult your manufacturer for further details.

Method four: Set you router and PC to communicate on same channel and standard manualy

1. Go to your router admin page which should be 192.168.1.1 (confirm with router manufacturer).

2. Navigate to WiFi settings and choose a channel which should comply with your location, for ex: 11. Save.

3. Choose Standard to broadcast WiFi signal as G only not abgn, bgn, gn (If your router is N capable and any PC in your home/office is only G ready). Save.

4. Go to your PC Network and Sharing Center (Windows 7) and Click on Change Adapter Settings, select you WiFi adapter, right click and choose Properties.

5. In pop up window select Configure, in next window click on Advance tab and browse settings there and choose same channel you choose in you router for ex: 11 and the same standard as G not abgn, bgn or gn. Save and Exit.